EBTC-MPPEL Battery Transfer Carriage Manual Extraction & Powered Lift

Battery Transfer Carriage Manual Extraction & Powered Lift

EBTC-MPPEL

Customize

This combination manual extraction and powered lift Battery Transfer Carriage features a hand wheel for extractor arm operation. Raising and lowering is accomplished with a center-mounted hydraulic cylinder controlled by a manual control valve with overload relief for additional safety. Power is supplied by a 12-volt hydraulic power unit. Lift range is from 5.5″ (140 mm) to 21.5″ (546 mm).

Note: Battery not included with EBTC models. Requires a 12-volt deep cycle battery with approximately 185 amp hour capacity. The battery must fit into an open top battery box with internal dimensions of 385mm x 182mm, and a height of 280mm. The battery may exceed these dimensions above the top of the battery box.

  • Provides safe and easy low cost battery handling solution
  • Versatile height adjustment allows battery extraction from most battery compartments
  • Large 6″ (152 mm) phenolic wheels help protect floors and provide low rolling resistance
  • Many flexible options available to satisfy unique battery handling requirements
  • Rubber Guards completely enclose chain and sprockets for safe operation
  • High 1,360 kg load capacity rating (based on 1,016 mm long battery – battery length longer than 1,016 mm will reduce capacity)
  • Power enclosure standard on all electric models allowing easy service and maintenance
7″ (178 mm) Cantilever (EBTC-CAN-7)
Extends extractor arm reach an additional 7″ (178 mm) and is ideal for use with outriggers
7″ (178 mm) Cantilever & 6″ (152 mm) Extension Bed (EBTC-CAN-7-6)*
7″ (178 mm) additional extractor arm reach is ideal for use with outriggers, and 6″ (152 mm) bed extension accommodates longer batteries
7″ (178 mm) Cantilever & 8″ (203 mm) Extension Bed (EBTC-CAN-7-8)*
7″ (178 mm) additional extractor arm reach is ideal for use with outriggers, and 8″ (203 mm) bed extension accommodates longer batteries
14″ (356 mm) Cantilever & 6″ (152 mm) Extension Bed (EBTC-CAN-14-6)*
14″ (356 mm) additional extractor arm reach is ideal for use with outriggers, and 6″ (152 mm) bed extension accommodates longer batteries
Note: Long batteries may reduce load capacity
Extra Capacity (EBTC-EC)*
Increases capacity to 3400 lb (1542 kg) while standard capacity is 3000 lb (1360 kg)
Note: Long batteries may reduce load capacity
Push-Arm Extension (EBTC-PA)
Low cost solution for extending extractor arm an additional 4″ (101 mm) past the standard 6″ (152 mm) extension
Rubber Bumper (EBTC-RB)
Protects lift truck during battery change-outs
Track Mount (EBTC-TM)
Provides dedicated location for battery change-out
Note: Single Guide Flat Track (SGT-F) is used for the Track Mount option, and minimum roller height is 152 mm with track mount

* Consult Factory on this option

  • EBTC-18MPPEL
  • EBTC-24MPPEL
  • EBTC-30MPPEL